Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MPC400SR — Trang 9/20

Code: 534

Description: Fusing rear fan error
The motor lock signal error is detected for 10 seconds after the motor lock signal was first detected.
Causes: • Defective fusing rear fan • Disconnected or defective harness • Defective BCU
Remedy: 1. Check or replace the harness. 2. Replace the fusing rear fan. 3. Replace the BCU.

Code: 535

Description: Drive unit fan error
The motor lock signal error is detected for 10 seconds after the motor lock signal was first detected.
Causes: • Defective drive unit fan • Disconnected or defective harness • Defective BCU
Remedy: 1. Check or replace the harness. 2. Replace the drive unit fan. 3. Replace the BCU.

Code: 536

Description: Toner supply fan error
The motor lock signal error is detected for 10 seconds after the motor lock signal was first detected.
Causes: • Defective toner supply fan • Disconnected or defective harness • Defective BCU
Remedy: 1. Check or replace the harness. 2. Replace the toner supply fan. 3. Replace the BCU.

Code: 540

Description: Fusing/Paper exit motor error
The BCU does not receive the lock signal 2 seconds after turning on the fusing/ paper exit motor.
Causes: • Motor overload • Defective fusing/paper exit motor
Remedy: 1. Check or replace the harness. 2. Replace the fusing/paper exit motor.

Code: 541

Description: Heating roller thermopile error
The temperature detected by the heating roller thermopile does not reach 0°C for 6 seconds.
Causes: • Loose connection of the heating roller thermopile • Defective heating roller thermopile • Defective thermopile
Remedy: 1. Check if the heating roller thermopile is firmly connected. 2. Replace the heating roller thermopile.

Code: 542

Description: Heating roller warm-up error 1
• The heating roller temperature does not reach 80°C for 20 seconds. • The center temperature of the heating roller does not reach the ready temperature for 90 seconds.
Causes: • Dirty or defective thermopile
Remedy: 1. Check if the heating roller thermopile is firmly connected. 2. Replace the thermopile.

Code: 543

Description: Heating roller fusing lamp overheat 1 (software error)
The temperature detected by the heating roller thermopile stays at 230°C for 1 second.
Causes: • Defective PSU • Defective IPU • Defective BCU
Remedy: 1. Replace the PSU. 2. Replace the IPU. 3. Replace the BCU.

Code: 544

Description: Heating roller fusing lamp overheat 1 (hardware error)
During stand-by mode or a print job, the temperature detected by the heating roller thermopile reaches 250 °C.
Causes: • Defective PSU • Defective IPU • Defective BCU • Defective fusing control system
Remedy: 1. Replace the PSU. 2. Replace the IPU. 3. Replace the BCU.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie