Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio SP4100N — Trang 3/8

Code: 621

Description: Communication error – FCI I2C
The engine board detected an unknown device on the I2C I/F bus (internal bus on the engine control board). The engine board detected an I2C I/F bus error. The number of devices connected to the I2C bus exceeded 12.
Causes: • Engine board defectiveI I2C

Code: 634

Description: Key/card counter device error 3
The backup battery of the counter device RAM is low.
Causes: • Replace the RAM backup battery.

Code: 635

Description: Key/card counter device error 4
After installation of the device a message alerts user to a battery voltage abnormal error.
Causes: • Device control board defective • Device control board backup battery defective

Code: 650

Description: Communication error – GAVD I2C
The engine board detected an unknown device on the I2C I/F bus (internal bus on the engine control board). The engine board detected an I2C I/F bus error. The number of devices connected to the I2C bus exceeded 12.
Causes: • Engine board defective

Code: 651

Description: Communication error – FCI I2C
The engine board detected an unknown device on the I2C I/F bus (internal bus on the engine control board). The engine board detected an I2C I/F bus error. The number of devices connected to the I2C bus exceeded 12.
Causes: • Engine board defectiveI I2C

Code: 669

Description: NVRAM Error
The NVRAM was not connected at power on, or read/write operations on the NVRAM failed.
Causes: • NVRAM connected improperly • NVRAM missing

Code: 670

Description: Engine startup error
The BCU failed to respond with the prescribed time when the machine was turned on.
Causes: • Connections between BCU and controller board are loose, disconnected, or damaged • Replace the BCU • Replace the controller board

Code: 672

Description: Controller startup error
After power on, the line between the controller and the operation panel did not open for normal operation. After normal startup, communication with the controller stopped.
Causes: • Controller stalled • Controller installed incorrectly • Controller board defective • Operation panel harness disconnected or defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie