Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh B010 Aficio 470W Dolphin

Code: SC192

Description: AMDP download error
The AMDP ROM enable signal could not be detected within 8 ms after program download to the AMDP started. Program download failed three times consecutively.
Causes: • AMDP program defective. • IC card defective • IPU defective

Code: SC302

Description: Charge Corona Output Error
Charge corona feedback voltage of less than 1V was detected for more than 200 s.
Causes: • Charge power pack is defective. • High voltage cable is defective. • Poor connection of the power pack connector. • Dirty charge corona unit caused leakage.

Code: SC303

Description: Charge corona wire cleaner error
1) Wire cleaner motor feedback voltage of less than 0.1 V was detected for more than 1s. 2) Corona wire cleaning did not complete within 80 s. 3) Charge wire cleaner did not return to the home position. 4) Cleaner does not move from the home position.
Causes: Wire cleaner motor connector disconnected. Wire cleaner motor connector disconnected. Wire cleaner motor is operating without a load. Wire cleaner stops due to an overload. Wire cleaner motor drive circuit malfunction.

Code: SC306

Description: Charge grid output error
Control PWM duty value is higher than 1% (FB less than 1V) for more than 200 ms (a grid current leak).
Causes: • CBG power pack is defective. • High voltage cable is defective. • Poor connection of the power pack connector. • Dirty charge corona unit causing leakage

Code: SC330

Description: Writing ASIC signal error
At power on, the stamp function could not execute successfully twice.
Causes: • SP5137 setting incorrect • Stamp board defective • Poor stamp board connection

Code: SC353

Description: ID sensor malfunction
SC353-1 Vsp is 0V or more than 2.5 V SC353-2 Vsg is 0V or more than 2.5 V SC353-3 Edge pattern voltage (2.5 V) cannot be detected SC353-4 LED drive current (PWM value) is over 1000 or fixed at 0. SC353-5 Vsg cannot be adjusted to 4 ±0.2V within 20 s.
Causes: • ID sensor defective • ID sensor connector defective • IOB malfunction • CBG power pack defective • Dirty ID sensor • VDB defective • LPH defective

Code: SC360

Description: Hard disk connection error
The connection of the optional HDDs could not be confirmed.
Causes: • Hard disk connectors disconnected. • Hard disk defective. • IPU board defective

Code: SC361

Description: Hard disk read error
Causes:
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie