Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh B125 Aficio 240W N-C1 — Trang 4/6

Code: 546-1

Description: Fusing Temperature Error 1
Fusing temperature goes up and down quickly, more than 20°C (68°C) at 1 sec. intervals.
Causes: • Check the thermistor connection. • Check the fusing lamp connections. • Replace the MCU.

Code: 546-2

Description: Fusing Temperature Error 2
Temperature goes up and down during a long interval, by 20°C (68°C) more than 3 times during a 60 sec. interval.
Causes: • Check the thermistor connection. • Check the fusing lamp connections. • Replace the MCU.

Code: 547

Description: Zero-Cross Signal Errors
The zero-cross signal from the ac power supply makes a trigger pulse to control the supply of power. It automatically detects 50/60 Hz.
Causes: • Check that the frequency of the power supply to the machine is correct. • Replace the PSU. • Replace the MCU

Code: 548

Description: Fusing Lamps Disconnected
The fusing temperature did not get to 100°C within 2 min. after the machine was switched on.
Causes: • Check the fusing lamp harness connections. • Replace the fusing lamps. • Replace the AC drive board.

Code: 549-1

Description: Pressure Roller Thermistor Error 1
Fusing temperature control detected that the analog voltage output by the pressure roller thermistor was more than 5V. The pressure roller thermistor is disconnected.
Causes: • Check the thermistor connection. • Replace the thermistor. • Replace the MCU.

Code: 549-2

Description: Pressure Roller Thermistor Error 2
(2 times at 1.5 sec. intervals) that the analog voltage output by the pressure roller thermistor was less than 0.2 V. The pressure roller thermistor has short-circuited.
Causes: • Check the thermistor connection. • Replace the thermistor. • Replace the MCU.

Code: 601

Description: Communication Error Between IPU and CIS
A break signal was detected after the communication connection. A communication error was sent back 3 times.
Causes: • Update the software. • Replace the MCU.

Code: 605

Description: Communication Error Between Controller and ECU
One of these problems occurred: • Serial communication error • Serial data overflowed in the receive data buffer.
Causes: • Replace the MCU.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie