Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh B190 Aficio 2228C J-C1k — Trang 11/20

Code: 687

Description: Memory address command error
Causes: • Loose connection • Defective controller • Defective BCU

Code: 690

Description: GAVD I2C communication error
690-001: Y 690-002: M 690-003: C 690-004: K • The I2C bus device ID is not identified during initialization. • A device-status error occurs during I2C bus communication. • The I2C bus communication is not established due to an error other than a buffer shortage.
Causes: • Loose connection • Defective BCU • Defective LD controller board

Code: 691

Description: Scanner startup error
• After the machine is powered on or recovering from the power save mode, the scanner ready signal is not verified.
Causes: • Board connector between controller and motherboard loose • Board connector between motherboard and IPU loose • IPU board defective • Controller board defective • Motherboard defective

Code: 692

Description: GAPCII2C communication error
Causes: • Loose connection • Defective BCU • Defective LD controller board

Code: 700

Description: ARDF original pick-up malfunction
• After the pick-up motor is turned on, the original stopper HP sensor is not activated.
Causes: • Original stopper HP sensor defective • Pick-up motor defective (not rotating) • Timing belt out of position • ARDF main board defective

Code: 701

Description: ARDF original pick-up/paper lift mechanism malfunction
• The original pick-up HP sensor is not activated after the pick-up motor is turned on.
Causes: • Original pick-up HP sensor defective • Pick-up motor defective • ARDF main board defective

Code: 722

Description: Two-tray finisher jogger motor error
• The jogger fences of the two-tray finisher donot return to home position within a specific time. • The two-tray finisher jogger motor does not leave home position within a given time.
Causes: • Defective jogger H.P. sensor • Loose connection • Defective jogger motor

Code: 724

Description: Two-tray finisher staple hammer motor error
Stapling does not finish within 150 ms after the staple hammer motor turns on.
Causes: • Staple jam • Loose connection • Overload caused by stapling too many pages • Defective staple hammer motor
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie