Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh B200 Aficio Color 5560 V-C1 — Trang 18/31

Code: SC533

Description: Fan error 4: fusing exhaust fan
The lock signal remained HIGH for 5 sec. while the fan that draws air out of the fusing unit was operating.
Causes: • Motor overload due to obstacle interfering with operation of the fan • Fan harness loose, disconnected, defective • Fan defective

Code: SC534

Description: Fan error 5: duplex exhaust fan
The lock signal remained HIGH for 5 sec. while the fan that draws air out of the duplex unit was operating.
Causes: • Motor overload due to obstacle interfering with operation of the fan • Fan harness loose, disconnected, defective • Fan defective

Code: SC541

Description: Heating roller thermistor 1 error 1: Poor connection
The temperature measured by the heating roller thermistor does not reach 130°C after 10 tries and 65 sec. have elapsed.
Causes: • Heating roller thermistor harness connection loose, disconnected, defective • Defective heating roller thermistor

Code: SC542

Description: Heating roller thermistor 1 error 2: No warmup
After the main switch is turned on or the cover is closed, the heating roller temperature does not reach the ready temperature within 2 sec. after the heater switches on. -or- If the roller was below 45°C, the heating roller did not reach the ready temperature 2 sec. after reaching 45°C. Note: Thermistor 2 stops monitoring the temperature once Thermistor 1 detects ready temperature.
Causes: • Thermistor is bent, installed incorrectly • Defective heating roller thermistor • Heating roller fusing lamp broken

Code: SC543

Description: Heating roller thermistor 1 error 3: Software - High temperature
The thermistor detected a temperature over 230°C times within 1 sec.
Causes: • TRIAC short, IOB defective • BICU defective • Fusing temperature out of control

Code: SC544

Description: Heating roller thermistor 1 error 4: Hardware - High temperature
The thermistor detected a temperature over 260°C
Causes: • TRIAC short • IOB defective • BICU defective • Fusing temperature control is erratic

Code: SC545

Description: Heating roller thermistor 1 error 5: Lamp remains on
After hot roller reaches warmup temperature, the fusing lamps remained on at full capacity for 25 sec. after reaching the warmup temperature while the hot roller was not rotating.
Causes: • Thermistor damaged, or out of position • Fusing lamp disconnected, broken

Code: SC546

Description: Heating roller thermistor 2 error 1: Thermistor disconnected
The temperature measured by the heating roller thermistor does not reach 0°C after 45 sec. and remains over this temperature for 10 readings.
Causes: • Loose connection of the heating roller thermistor • Defective heating roller thermistor
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie