• Code: 211
• Description: Main scan encoder error
  The carriage unit does not stop at home position (rear side) or reverse position (front side).
• Causes: • Defective main scan drive motor • Main scan encoder coming off • Defective main scan encoder sensor

• Code: 503
• Description: Tray 2 (optional paper tray unit) feed error
  • The lift sensor is not activated within 18 seconds twice consecutively after the tray lift motor starts lifting the bottom plate. • When the tray lowers, the tray lift sensor does not go off within 1.5 sec twice consecutively.
• Causes: • Defective or disconnected tray lift motor • Paper or other obstacle trapped between tray and motor • Pick-up solenoid disconnected or blocked by an obstacle • Reverse connection of harness

• Code: 504
• Description: Tray 3 (optional paper tray unit) feed error
  • The lift sensor is not activated within 18 seconds twice consecutively after the tray lift motor starts lifting the bottom plate. • When the tray lowers, the tray lift sensor does not go off within 1.5 sec twice consecutively.
• Causes: • Defective or disconnected tray lift motor • Paper or other obstacle trapped between tray and motor • Pick-up solenoid disconnected or blocked by an obstacle • Reverse connection of harness

• Code: 506
• Description: Paper feed motor lock error (optional paper tray unit) A motor lock signal is not detected for more than 1.5 s or the lock signal is not detected for more than 1.0 s during rotation.
• Causes: • Defective paper feed motor • Too much load on the drive mechanism

• Code: 520
• Description: Sub scan motor error
  The sub scan motor does not reply for 100ms when a machine sends the "stop" command to the sub scan motor.
• Causes: • Defective sub scan encoder sensor • Timing belt of the sub scan encoder is come off. • Defective sub scan motor

• Code: 570
• Description: Charge bias leak
  High voltage unit sends a signal of charge bias leak.
• Causes: • Defective charge roller • Defective high voltage unit

• Code: 571
• Description: Ink head temperature error
  The temperature sensor at the ink head detects unusual temperature for 0.8 seconds.
• Causes: • Disconnect harness • Defective temperature sensor at the ink head

• Code: 572
• Description: Belt temperature error
  The temperature sensor at the belt unit detects unusual temperature for 0.8 seconds.
• Causes: • Disconnect harness • Defective temperature sensor at the ink head