Description: Transfer roller leak error (positive electrode)
The feedback voltage of the transfer roller is insufficient.
Causes: • Defective high voltage supply board
• Loose connection of the PCU
• Incorrect installation of the transfer unit or the separation unit
• Defective transfer roller
Description: Transfer roller leak error (negative electrode)
The feedback voltage of the transfer roller is insufficient.
Causes: • Defective high voltage supply board
• Loose connection of the PCU
• Incorrect installation of the transfer unit or the separation unit
• Defective transfer roller
Description: Main motor error
A main motor lock signal is not detected for more than 7 consecutive checks (700 ms) after the main motor starts to rotate, or the lock signal is not detected for more than 7 consecutive checks during rotation after the last signal.
Causes: - Too much load on the drive mechanism
- Main motor defective
Description: Tray 2 lift motor malfunction (Optional paper tray units)
The paper lift sensor fails to activate twice continuously after the tray lift motor has been on for 18 seconds.
Causes: - Paper lift sensor defective
- Tray lift motor defective
- Too much load on the drive mechanism
- Poor tray lift motor connection
Description: Tray 3 lift motor malfunction (optional paper tray units)
The paper lift sensor fails to activate twice continuously after the tray lift motor has been on for 18 seconds.
Causes: - Paper lift sensor defective
- Tray lift motor defective
- Too much load on the drive mechanism
- Poor tray lift motor connection
Description: Tray 4 lift motor malfunction (optional two-tray paper tray unit)
The paper lift sensor fails to activate twice continuously after the tray lift motor has been on for 18 seconds.
Causes: - Paper lift sensor defective
- Tray lift motor defective
- Too much load on the drive mechanism
- Poor tray lift motor connection
Description: Paper feed motor lock (optional paper tray units)
A motor lock signal is not detected for more than 1.5 s or the lock signal is not detected for more than 1.0 s during rotation.
Causes: - Paper feed motor defective
- Too much load on the drive mechanism
Description: Fusing thermistor open (center)
The fusing temperature detected by the thermistor is below 71C and is not corrected after the main power switch is turned on.
Causes: - Fusing thermistor defective or out of position
- Power supply board defective
- Loose connectors
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.