Mã lỗi Ricoh B289 MPW3600 Neptune-C2 — Trang 10/11
Code:
Tất cả lỗi (87)
143
144
300
305
392
400
401
402
440
460
508
520
521
522
530
541
542
543
545
546
547
551
553
557
559
561
563
628
632
633
634
635
650
651
670
672
690
720
762
763
790
819
820
821
822
823
824
826
827
828
829
838
853
854
855
856
857
860
861
863
864
865
866
867
868
870
873
874
875
880
900
901
910 ... 914
919
920
921
953
954
955
964
965
967
990
991
992
997
998
Description: 910 B External controller error 1 911 B External controller error 2 912 B External controller error 3 913 B External controller error 4 914 B External controller error 5
Causes: The external controller alerted the machine about an error.
Remedy: • Refer to the instructions for the external controller
Description: External controller error 6 While EAC (External Application Converter), the conversion module, was operating normally, the receipt of a power line interrupt signal from the FLUTE serial driver was detected, or BREAK signal from the other station was detected.
Causes: • Controller RW3600 power outtage • Controller RW3600 rebooted • Connection to Controller RW3600 loose
Remedy:
Description: Printer error 1 An internal application error was detected and operation cannot continue.
Causes: • Software defective • Turn the machine power off/on, or change the controller firmware • Insufficient memory
Remedy:
Description: Printer Error 2. When the printer application started, the font designated for use could not be found on the SD card.
Causes: • The font is not on the SD card
Remedy:
Description: Scanner start error The job was ready to start with the selected image processing mode, but the program did not receive a start signal from the IPU.
Causes: • Firmware bug • Update the scanner firmware • IPU defective
Remedy:
Description: Printer Image Setting Error The settings that are required for image processing using the printer controller are not sent from the IPU.
Causes: • Firmware bug • IPU defective
Remedy:
Description: Memory Setting Error The settings that are required for image processing using the memory are not sent from the IPU.
Causes: • Firmware bug • Hard disk unit defective • Controller defective • MCU defective • IPU defective
Remedy:
Description: Scanner Start Error During scanned image processing, another command to start scanning was received.
Causes: • Scanner firmware defective • Update scanner firmware
Remedy: