Description: TD sensor error: Auto adjust error
During automatic adjustment of the TD sensor, output voltage is less than 1.8V or more than 4.8V during TD sensor initial setting.
Description: Development output abnormal
A development bias leak signal is detected. High voltage output to the development unit exceeded the upper limit (65%) for 60 ms.
Causes: • High voltage supply board defective • Poor connection at the development bias terminal • Poor connection at the high voltage supply board
Description: Transfer belt position sensor error
The transfer belt position sensor does not activate even if the transfer belt contact clutch has been switched on twice and rotated once.
Causes: • Main motor/drive malfunction • Transfer belt contact clutch defective • Transfer belt position sensor defective • Harness disconnected
Description: Transfer belt error
The transfer belt does not move away from the drum during ID sensor pattern checking.
Causes: • Main motor/drive malfunction • Transfer belt position sensor defective • Poor transfer belt position sensor connection • Transfer belt contact clutch defective
Description: Main motor lock
The PLL lock signal remained HIGH while the main motor was off, and when the motor was turned on, the signal remained LOW for 2 sec.
Causes: • Physical overload on drive mechanism • Main motor drive board (PCB) defective
Description: Feed Development Motor Error
The PLL lock signal remained HIGH while the feed development motor was off, and when the motor was turned on, the signal remained LOW for 2 sec.
Causes: • Motor lock caused by physical overload. • Motor drive board (PCB) defective.
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.