Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh B296 MP3500 A-C4.5

Code: 101

Description: Exposure lamp error
The standard white level was not detected properly when scanning the white plate.
Causes: • Exposure lamp defective • Lamp stabilizer defective • Exposure lamp connector defective • Standard white plate dirty • Scanner mirror or scanner lens out of position or dirty • SBU defective

Code: 120

Description: Scanner home position error 1
The scanner home position sensor does not detect the on condition during initialization or copying.
Causes: • SIB or scanner drive motor defective • Scanner motor defective • Harness between SIB and scanner drive motor disconnected • Harness between SIB and scanner drive motor power source disconnected • Scanner HP sensor defective • Harness between SIB and HP sensor disconnected • Scanner wire, timing belt, pulley, or carriage defective

Code: 121

Description: Scanner home position error 2
The scanner home position sensor does not detect the off condition during initialization or copying.
Causes: • SIB or scanner motor drive board defective • Scanner motor defective • Harness between SIB and scanner drive motor disconnected • Harness between SIB and scanner drive motor power source disconnected • Scanner HP sensor defective • Harness between SIB and scanner HP sensor disconnected • Scanner wire, timing belt, pulley, or carriage defective

Code: 143

Description: SBU auto adjust error
One of the following occurred: When the machine was powered on, automatic adjustment of the SBU failed. Automatic white density adjustment failed when reading standard white plate
Causes: • Exposure lamp defective • Lamp stabilizer defective • Lamp stabilizer connection loose, disconnected or damaged • White plate mounting is incorrect or defective • Scanner mirror or scanner lens out of position or dirty • SBU defective • BICU (Ri10) defective • SIB defective • Harness connections between SIB and SBU loose, disconnected, or damaged.

Code: 144

Description: SBU communication error
Immediately after power on, the operation check done by the SIB for the SBU failed because the SBU was not operating normally.
Causes: • Flat film or harness connectors between the SBU and SIB are loose, disconnected, or damaged • Replace SBU • Replace BICU

Code: 165

Description: Copy Data Security Unit error
An error occurred when the machine attempted to set the Copy Data Security Unit SD card.
Causes: • The Copy Data Security Unit card not installed • The Copy Data Security Unit card is installed, but it is not the correct type for the machine.

Code: 302

Description: Charge roller current leak
A charge roller current leak signal was detected.
Causes: • Charge roller damaged • High voltage supply board defective • PCU harness defective or disconnected

Code: 304

Description: Charge roller current correction error
The charge roller bias correction is performed twice even if the maximum charge roller bias (-2000V) is applied to the roller.
Causes: • ID sensor defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie