Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh D049 MPW7140 Be-C1

Code: SC101

Description: Lamp error Lamp does not light at power on.
Causes: If cycling the machine power off/on does not solve the problem: • Clean the white plate • Clean the CIS glass • Lamp regulator connection loose broken, defective • CIS, IPU, BCU connection loose broken defective • Harness connection between Xenon lamp and lamp regulator loose broken defective • Harness between CIS and IPU loose, broken, defective • Harness between CIS and PSU loose, broken, defective • One or more defective: CIS, IPU, BCU, PSU, Xenon lamp
Remedy:

Code: SC144

Description: CIS communication error A serial communication error occurred with the CIS due to a PCB malfunction or loose connection.
Causes: If cycling the machine power off/on does not solve the problem: • Harness between CIS and IPU loose broken defective • Harness between CIS and PSU loose, broken, defective • CIS defective • IPU defective • BCU defective
Remedy:

Code: SC161

Description: IPU Error Three attempts to configure the Cetus chip on the IPU board failed when the machine was switched on or when machine recovered from the energy save mode.
Causes: • Replace the IPU
Remedy:

Code: SC180

Description: Left scanner fan lock The BCU detected a left scanner fan lock signal 5 sec. after the machine was switched on.
Causes: If cycling the machine power off/on does not solve the problem: • Left scanner fan harness connection to the IOB loose, broken, defective • Left scanner fan defective • IOB defective • BCU defective
Remedy:

Code: SC181

Description: Right scanner fan lock The BCU detected a right scanner fan lock signal 5 sec. after the machine was switched on.
Causes: If cycling the machine power off/on does not solve the problem: • Left scanner fan harness connection to the IOB loose, broken, defective • Left scanner fan defective • IOB defective • BCU defective
Remedy:

Code: SC186

Description: Gray balance adjustment error
Causes: The value for gray balance was detected out of range after gray adjustment.
Remedy: If cycling the machine power off/on does not solve the problem: • Clean the white strip • Clean the CIS glass • Check the following harnesses for loose, broken, or defective connectors: 1. Xe lamp to lamp regulator 2. Lamp regulator to CIS 3. CIS to IPU 4. CIS to IPU 5. IPU to IOB • One of the following boards is defective 1. CIS 2. IPU 3. IOB 4. BCU

Code: SC191

Description: Original exit roller thermistor error The original exit roller thermistor reading was abnormal.
Causes: • Thermistor connection loose, broken, defective • Thermistor short • Harness between thermistor and IOB loose, broken, defective • IOB defective • BCU defective
Remedy:

Code: SC300

Description: Charge corona output error Charge corona feedback voltage less than 0.5 V was detected for more than 200 sec after power on.
Causes: • TD power pack defective. • High voltage cable defective. • Dirty charge corona wire caused voltage leak
Remedy:
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie