Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh D182 MP2553 OR-C2 — Trang 15/30

Code: SC701-03

Description: Paper Feed Motor Driver Error (ARDF)
Causes: Detection of error signal from motor driver • Encoder disconnection • Encoder connector dropout • Encoder defective • Overload • Motor deterioration
Remedy: • Replace the harness • Check the harness connection • Replace the motor

Code: SC701-08

Description: Paper Exit Motor Driver Error (ARDF)
Causes: Detection of error signal from motor driver • Encoder disconnection • Encoder connector dropout • Encoder defective • Overload • Motor deterioration
Remedy: • Replace the harness • Check the harness connection • Replace the motor

Code: SC702-01

Description: Protection Device Intercept Error 1 (ARDF) When original source 5V power supply is ON, protection device intercept of 24V power supply system is detected.
Causes: Any of feed motor, transport motor, reverse solenoid, paper feed solenoid, paper feed clutch and FAN motor defective, a harness shortcircuit occurs, and the protection device of the 24V power supply system intercepts.
Remedy: • Replace the ARDF main board. • Replace the short-circuited parts.

Code: SC702-02

Description: Protection Device Intercept Error 2 (ARDF) When original source 5V power supply is ON, protection device intercept of 24V OUT power supply system is detected.
Causes: Solenoid defective or harness short-circuit occurs in 24VOUT power supply system.
Remedy: • Replace the ARDF main board. • Replace the short-circuited parts.

Code: SC702-03

Description: Protection Device Intercept Error 3 (ARDF) When original source 5V power supply is ON, protection device intercept of 5VE power supply system is detected.
Causes: Sensor defective or a harness short-circuit occur in 5VE power supply system.
Remedy: • Replace the ARDF main board. • Replace the short-circuited parts.

Code: SC721-03

Description: Protection Device Intercept Error 1 (1000-sheet finisher) Fuse blowout is detected
Causes: Over current (board defective, harness short-circuit, solenoid defective)
Remedy: • Replace the harness. • Replace the solenoid. • Replace the finisher main board.

Code: SC721-10

Description: Transport Motor 1 Error (1000-sheet finisher) Motor driver detects an error state (DC motor control error) (1st time is jam notification, 2nd time is SC notification).
Causes: • Motor defective • Connector disconnected • Overload • Encoder error
Remedy: • Replace the motor. • Reset the connector. • Replace the harness. • Replace the finisher main board.

Code: SC721-11

Description: Transport Motor 2 Error (1000-sheet finisher) Motor driver detects an error state (DC motor control error) (1st time is jam notification, 2nd time is SC notification).
Causes: • Motor defective • Connector disconnected • Overload • Encoder error
Remedy: • Replace the motor. • Reset the connector. • Replace the harness. • Replace the finisher main board.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie