Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh D236 MPC306 GR-C2 — Trang 28/29

Code: 878-01

Description: USB flash error There is a problem in the file system of the USB flash memory.
Causes: USB Flash system files corrupted
Remedy: Replace the controller board.

Code: 878-02

Description: TPM error An error occurred in either TPM or the TPM driver
Causes: TPM not operating correctly
Remedy: Replace the controller board.

Code: 878-03

Description: TCSD error An error occurred in the TPM software stack.
Causes: • TPM, TPM software cannot start • A file required by TPM is missing
Remedy: Replace the controller board.

Code: 880-00

Description: MLB error Reply to MLB access was not returned within a specified time.
Causes: MLB defective
Remedy: • Replace the MLB. • Remove the MLB.

Code: 881-01

Description: Management area error • A problem was detected in the software • This error may even occur is an IC card option is not installed.
Causes: • This is caused by accumulation of abnormal authentication information in the software. (User operation will not directly cause it.) • At login Example: When a job is sent to the printer/when logged on from the operation panel/when logged on from a Web browser
Remedy: Cycle the main power off and on.

Code: 899-00

Description: Software performance error (signal reception end) Unknown software error occurred.
Causes: Occurs when an internal program behaves abnormally.
Remedy: In the case of a hardware defect • Replace the hardware. In the case of a software error • Cycle the main power off and on. • Try updating the firmware.

Code: 900-00

Description: Printer application error (no response within determined time in Printing). Electrical total counter error The total counter contains data that is not a number.
Causes: • NVRAM incorrect type • NVRAM defective or corrupted • Unexpected error from external source • When PRT received signals at SRM, the requested count did not complete.
Remedy: Replace the NVRAM.

Code: 920-01

Description: Printer application error (Timeout during Printing). When an error is detected in the application, which makes continued operation impossible.
Causes: • Software bug • Unexpected hardware configuration (such as insufficient memory)
Remedy: • Cycle the main power off and on. • Increase the memory storage capacity.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie