Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh D251 MP3354 Cor-C1 — Trang 14/40

Code: SC564-00

Description: Fusing High Temperature Detection (hardware) (Pressure Roller Thermistor Error) In the event of an error
Causes: • Triac short-circuit • Pressure roller thermistor defective • BCU controller defective • Fusing control: out of control
Remedy: • Replace the BCU. • Replace the pressure roller thermistor. • Replace the fusing unit.

Code: SC571-00

Description: Pressurized Edge Thermistor Disconnection When the pressurized edge thermistor detects a predetermined temperature or less for specified seconds consecutively. Detection period: 100 ms, detection counts: 10 times or more.
Causes: • Thermistor disconnection • Connector disconnected
Remedy: • Replace the thermistor. • Reset the connector. • Replace the connector. • Replace the fusing unit.

Code: SC572-02

Description: Pressurized Edge Thermistor Does Not Reload When the temperature does not reach 40 degrees Centigrade for 100 seconds consecutively.
Causes: • Thermistor dirt • Thermistor deformation, float • Outside input voltage guarantee • After excess temperature rise prevention unit operation
Remedy: • Replace the thermistor. • Make sure that the input voltage is within acceptable limits. • Replace the fusing unit.

Code: SC573-00

Description: Pressurized Edge Thermistor High Temperature Detection (software) When the pressurized edge thermistor detects a predetermined temperature or above for specified second consecutively.
Causes: • Triac short-circuit • IOB defective • BCU defective
Remedy: • Replace the IOB. • Replace the BCU. • Replace the fusing unit.

Code: SC574-00

Description: Pressurized Edge Thermistor High Temperature Detection (hardware) Above a predetermined temperature detected
Causes: • Triac short-circuit • Pressure roller thermistor defective • BCU defective • Fusing control: out of control
Remedy: • Replace the BCU. • Replace the pressure roller thermistor. • Replace the fusing unit.

Code: SC589-01

Description: Fusing center: Low Temperature Detection When the fusing center thermopile detects the temperature which is 180 degrees Centigrade lower than target Temperature for 12 seconds consecutively.
Causes: • Heater harness disconnected • Connector defective
Remedy: • Replace the Heater harness. • Replace the connector.

Code: SC589-02

Description: Fusing edge: Low Temperature Detection When the fusing edge thermopile detects the temperature which is 180 degrees Centigrade lower than target Temperature for 12 seconds consecutively.
Causes: • Heater harness disconnected • Connector defective
Remedy: • Replace the Heater harness. • Replace the connector.

Code: SC620-01

Description: ADF Communication Error. After ADF connection was recognized on startup, an error is detected. (disconnection detection)
Causes: • ADF connection fault • ADF defection • IPU board defection • Noise contamination • ADF machine code unmatched
Remedy: • Check the ADF cable connection • Replace the ADF • Replace the IPU board • Replace the ADF which matches the machine code
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie