Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh D251 MP3354 Cor-C1 — Trang 38/40

Code: SC878-00

Description: TPM authentication error TPM electronic recognition failure
Causes: • Update of system module attempted without correct update path • USB flash memory not operating correctly
Remedy: Replace the controller board.

Code: SC878-01

Description: USB flash error There is a problem in the file system of the USB flash memory.
Causes: USB Flash system files corrupted
Remedy: Replace the controller board.

Code: SC878-02

Description: TPM error An error occurred in either TPM or the TPM driver
Causes: TPM not operating correctly
Remedy: Replace the controller board.

Code: SC878-03

Description: TCSD dffof. An error occurred in the TPM software stack.
Causes: • TPM, TPM software cannot start • A file required by TPM is missing
Remedy: Replace the controller board.

Code: SC880-00

Description: MLB error Reply to MLB access was not returned within a specified time.
Causes: MLB defective
Remedy: • Replace the MLB. • Remove the MLB.

Code: SC881-01

Description: Management area error • A problem was detected in the software • This error may even occur is an IC card option is not installed.
Causes: • This is caused by accumulation of abnormal authentication information in the software. (User operation will not directly cause it.) • At login Example: When a job is sent to the printer/when logged on from the operation panel/when logged on from a Web browser
Remedy: Turn the main power off/on.

Code: SC899-00

Description: Software performance error (signal reception end) Unknown software error occurred.
Causes: Occurs when an internal program behaves abnormally.
Remedy: In case of a hardware defect • Replace the hardware. In case of a software error • Turn the main power off/on. • Try updating the firmware.

Code: SC900-00

Description: Electrical total counter error The total counter contains data that is not a number.
Causes: • NVRAM incorrect type • NVRAM defective or corrupted • Unexpected error from external source • When PRT received signals at SRM, the requested count did not complete.
Remedy: Replace the NVRAM.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie