Các lỗi thường gặp

Code :
  • Code: 543
  • Description: Fusing overheat error (center)
    The fusing temperature is over 230°C for 1 second (detected by the thermistor).
  • Causes: • Fusing thermistor defective • Power supply board defective
  • Code: 544
  • Description: Fusing overheat error (center) 2
    The fusing temperature is over 250°C for 1 second (detected by the fusing temperature monitor circuit).
  • Causes: • Fusing thermistor defective • Power supply board defective
  • Code: 545
  • Description: Fusing lamp overheat error (center)
    After the fusing temperature reaches the target temperature, the fusing lamp does not turn off for 12 consecutive seconds.
  • Causes: • Fusing thermistor defective or out of position • Power supply board defective
  • Code: 546
  • Description: Unstable fusing temperature (center)
    The fusing temperature varies 50°C or more within 1 second, and this occurs 2 consecutive times.
  • Causes: • Thermistor defective or out of position • Power supply unit defective
  • Code: 547
  • Description: Zero cross signal malfunction
    Zero cross signals are not detected within 5 seconds after the main power switch is turned on, or are not detected within 1 second after operation begins.
  • Causes: • Power supply board defective • BICU defective
  • Code: 551
  • Description: Fusing thermistor open (rear)
    The fusing temperature detected by the thermistor is below 71°C and is not corrected after the main power switch is turned on.
  • Causes: • Fusing thermistor defective or out of position • Power supply board defective • Loose connectors
  • Code: 552
  • Description: Fusing temperature warm-up error (rear)
    The fusing temperature rises less than 7 degrees in 2 seconds, and this continues 5 times consecutively. The fusing temperature is not detected in 25 or 35 seconds.
  • Causes: • Fusing thermistor defective or out of position • Fusing lamp open • Power supply board defective
  • Code: 553
  • Description: Fusing overheat error (rear)
    The fusing temperature is over 230°C for 1 second (detected by the thermistor).
  • Causes: • Fusing thermistor defective • Power supply board defective
 < 1 2 3 4 5 6 7 >  Last ›
popup

Số lượng:

Tổng tiền:

Danh mục