• Code: 193
• Description: Image transfer error
  Scanned images are not transferred to the controller memory within 1 minute.
• Causes: • BICU board defective • Controller board defective

• Code: 198
• Description: Memory address error
  The BICU board does not receive memory addresses from the controller board.
• Causes: • The firmware programs of the engine and the controller do not match. • BICU board defective • Controller board defective

• Code: 202
• Description: Polygon Motor Error 1: ON Timeout
  The machine does not detect the polygon motor lock signal for 10 seconds after the polygon motor has turned on.
• Causes: • Polygon motor defective • SCRATCH error • I/F harness disconnected or loose

• Code: 203
• Description: Polygon Motor Error 2: OFF Timeout
  The machine does not detect the polygon motor unlock signal for 3 seconds after the polygon motor has turned off.
• Causes: • Polygon motor defective • SCRATCH error • I/F harness disconnected or loose

• Code: 204
• Description: Polygon Motor Error 3: XSCRDY Signal Error
  The machine does detect the polygon motor unlock signal for 0.2 seconds after the polygon motor has turned on.
• Causes: • Polygon motor defective • SCRATCH error • I/F harness disconnected or loose

• Code: 220
• Description: Laser synchronization error
  The main scan synchronization detector board cannot detect the laser synchronization signal for more than 5 consecutive 100 ms intervals.
• Causes: • Poor connection between the LD unit and the BICU board • Damaged cable between BICU and LD unit • LD unit out of position • LD unit defective • BICU board defective

• Code: 230
• Description: No laser writing signal (F-GATE) error
  The laser-writing signal (F-GATE) fails to turn Low after the laser crosses 5 mm on the drum surface from the laser writing start position.
• Causes: • BICU board defective • The fax controller or printer controller has a poor connection • Fax controller or printer controller defective

• Code: 302
• Description: Charge roller current leak
  A current leak signal for the charge roller is detected.
• Causes: • Charge roller damaged • High voltage supply board defective • Poor connection of the PCU