• Code: T17
• Description: Replace Battery
  • When the battery voltage is less than 2.4 V at power-on, all reset, or end of operation.

• Code: T18
• Description: Sorter Error
  • If an error signal is received from the sorter.

• Code: T19
• Description: Thermal Pressure Motor Lock
  • If the TPH Pressure switch has not been depressed within 4 seconds after the TPH Pressure motor was activated to lower the TPH.
  • If the TPH Pressure switch has not been released within 4 seconds after the TPH Pressure motor was activated to raise the TPH.

• Code: T2
• Description: Elevator Motor Lock
  • In 15 seconds from turning ON of the Elevator motor in upward direction, the Elevator upper limit sensor is not pushed.
  • In 15 seconds from turning ON of the Elevator motor in downward direction, the light path of the Elevator lower limit sensor is not blocked.
  • In 3 seconds from turning ON of the Elevator motor in upward direction, the Elevator lower sensor is held blocked.
  • In 3 seconds from turning ON of the Elevator motor in downward direction, the Elevator upper limit sensor is held pressed down.

• Code: T20
• Description: Wing Motor Lock
  • If neither of the Jump wing sw1 or sw2 has been depressed within 5 seconds after the Wing motor was activated.
  • If neither of the Jump wing sw1 or sw2 has been released within 5 seconds after the Wing motor was activated.

• Code: T3
• Description: Clamp Error (1)
  • In 4 seconds from turning ON of the Clamp solenoid in clamp retrial, the Clamp safety switch is held still pressed down.
  • In 4 seconds from turning OFF of the Clamp solenoid, the Clamp safety SW has not been pressed.
  • In 8 seconds from turning ON of the Clamp motor in opening direction in clamp retrial, the 180° Angular sensor has not detected magnet.
  • In 8 seconds from turning ON of the Clamp motor in closing direction in clamp retrial, the 0° Angular sensor has not detected magnet.
  In any of the above cases, master making is performed to the end.

• Code: T30
• Description: P. -F. Tray Slide Pulse Motor
  • When the Paper feed tray position sensor is not turned on/ off within 165 pulses(approx. 3 second) after the P. -F. tray slide pulse motor is turned on.

• Code: T4
• Description: Overflow
  • When ink is in contact with the Overflow sensor. The Drum set switch need be pushed.