Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Riso RZ230 — Trang 17/31

Code: P03-508

Description: Clamp sensor A is ON after the A-position compensating movement is completed.

Code: P03-545

Description: Clamp unit is not in the home position while the print drum is in movement (cause due to the clamp motor).

Code: P04-513

Description: The overflow sensor was ON for a set number of times in succession during the 10-millisecond-interval overflow-sensor check.

Code: P05-603

Description: The vertical-centering sensor does not switch ON even when the vertical-positioning pulse motor activated in the image-down direction for5 seconds during vertical home positioning movement.

Code: P05-604

Description: The vertical-centering sensor does not switch OFF even when the vertical-positioning pulse motor activated in the image-up direction for 5seconds during vertical home positioning movement.

Code: P05-605

Description: Even though the vertical positioning motor stopped according to the vertical centering sensor detection, the stopping position does notcorrespond with the programmed position. (GA control error).

Code: P05-612

Description: The one-step-positioning key was pressed with vertical-print-position information undefined.

Code: P08-951

Description: Print job executed was not in correct RisoRinc format.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie