Description: Occurs when the Motor can not be controlled.
Causes: The Output Voltage(41v) from the Switching Power Unit is not supplied. The Power Cable is not connected correctly. / The Powe Cable is broken. The Motor Driver IC on the Main Board is broken.
Description: Occurs when the big current is flowed during acceleration in the Feed Direction.
Causes: When the cutting starts without the Pre-feed, it occurs the over load because the Roll-sheet is pulled from the Shaft. The heavy sheet, such as the Sand Blast is used with the normal or high-speed mode. The movement of the Grit Roller is heavy because of the over load.
Description: Occurs when the big current is flowed during the stable movement in the Feed Direction.
Causes: When the cutting starts without the Pre-feed, it occurs the over load because the Roll-sheet is pulled from the Shaft. The heavy sheet, such as the Sand Blast is used with the normal or high-speed mode. The movement of the Grit Roller is heavy because of the over load.