Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Roland SC545EX — Trang 2/2

Code: 0107

Description: Unset up of the Linear Encoder
Linear Encoder Setup has not been done.
Causes: Linear Encoder Setup has not been done.

Code: 0108

Description: Wiper Unit Protection Error
Even though the machine carries out the regular movement, the output of the Wiper Height Sensor does not reach the expected value.
Causes: Disorder of Wiper Height Sensor Fault of Wiper Unit Fault of Wiper Height Sensor Cut-line or short-circuit of Cable and Flexible Cable

Code: 0109

Description: Wiper Protection Error
Even though the machine carries out the regular movement, the output of the Wiper Sensor does not reach the expected value.
Causes: Disorder of Wiper Sensor Fault of Wiper Unit Fault of Wiper Sensor Cut-line or short-circuit of Cable and Flexible Cable

Code: 0110

Description: Linear Encoder Error
Input value from Linear Encoder is not changed when Linear Encoder is set up the Origin. When Motor stops during printing, Motor does not complete the movement which is supposed to be done.
Causes: Read error of Linear Encoder Read error of Encoder on Scan Motor side Wire is not fixed to Head Carriage firmly.

Code: 0111

Description: Tool / Crop Error
This error occurs when the machine performs the Auto Crop Mark Detection or the Auto Print / Cut adjustment without the Tool / Crop Mark Sensor Adjustment.
Causes: Tool / Crop Mark Sensor Adjustment has not been performed.

Code: Err

Description: The SV or the set values of some parameters have been changed without any operation.
Causes: Parameter settings of [P-SL], [P-SU] and [P-n2] are not correct. Parameter settings of [P-SL], [P-SU] and [P-n2] are not correct. When the set value of [P-SU] is larger than 1000, "1" will be registered for [P-DP].

Code: UUUU, LLLL

Description:
Causes: Parameter setting of [P-n2] is not correct. The Cable of the Thermistor which is fixed to the Controller is broken or short-circuit. The Cable of the Thermistor which is fixed to the Controller is loose. The Thermistor is broken. Parameter settings of [P-SL], [P-SU] and [P-n2] are not correct.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie