Code :

Code: 25
Display: Press Cont Key Replace T2 Roller
Description: The T2 roller is coming to the end of its usable life and will need replacing soon.
Remedy: * Press the [On-Line/Continue] button to continue printing. * Replace the T2 roller when the image quality becomes unacceptable. * You can select if this message will be displayed on the LCD Pane or not.

Code: 26
Display: Ready IP Conflict
Description: IP address conflict with the address of another device on the network.
Remedy: This only occurs when the optional network interface is connected and configured for TCP/IP support. Change the IP Address

Code: 27
Display: Ready [CMYK] Low Toner
Description: The indicated Toner Color cartridge is almost empty.
Remedy: Replace the indicated Color Toner Cartridge. To temporarily improve printing for a short time remove the indicated toner cartridge and rock it gently from side to side for a short time before replacing it.

Code: 28
Display: Replace Drum Cartridge
Description: This occurs when the OPC drum is not correctly installed.
Remedy: 1. Check that the OPC Unit is installed and locked correctly. 2. Check the OPC OEM Harness to the Main PBA. • Refit or replace the harness if it is damaged. 3. Replace the Main PBA.

Code: 29
Display: Replace Image Transfer
Description: There is a problem with the ITB Unit installation.
Remedy: * This occurs when the ITB Unit is not correctly installed and locked * This occurs when the value of the OEM Resistor in the ITB Unit is incorrectly detected due to contamination of the contact. 1. Open the Top Cover and then check that the ITB Unit is installed and locked correctly. 2. Clean the contacts on the ITB Unit 3. Replace the ITB unit.

Code: 30
Display: Replace Toner [Color]
Description: Toner Cartridge is not installed.
Remedy: * This occurs when the indicated Toner Cartridge is not installed. * This occurs when the value of the OEM Resistor in the Toner Cartridge is incorrectly detected due to contamination of the contacts. 1. Open the Deve Cover and check that the Toner Cartridge is installed. 2. Clean the 3 contact points on the Toner Cartridge and then re-install. 3. Remove the Front Cover and then check the condition of the spring contacts between the DEVE OEM PBA and Toner Cartridge if the same error occurs. * Terminal : parts name(MEA UNIT-TERMINAL,JC97-01771A) --> Clean and Re-assemble. 4. Replace the Toner Cartridge if the same error recurs. 5. Replace the DEVE OEM PBA, HVPS and Main PBA in order if the same error recurs.

< 1 2 3 4 5 >