Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Sharp AL1622 — Trang 4/7

Code: F9-82

Description: Printer PWB communication trouble (Overrun)
Communication trouble between MCU and printeu PWB (Overrun error)
Causes: Printer PWB connector disconnection Printer PWB MCU PWB harness failure Printer PWB mother board connector pin breakage. Printer PWB ROM defect, data failure

Code: F9-84

Description: Printer PWB communication trouble (Framing)
Communication trouble between MCU and printer PWB (Framing error)
Causes: Printer PWB connector disconnection Printer PWB MCU PWB harness failure Printer PWB mother board connector pin breakage. Printer PWB ROM defect, data failure

Code: F9-88

Description: Printer PWB communication trouble (Time-out)
Communication trouble between MCU and printeu PWB (Time-out error)
Causes: Printer PWB connector disconnection Printer PWB MCU PWB harness failure Printer PWB mother board connector pin breakage. Printer PWB ROM defect, data failure

Code: H2-00

Description: Thermistor open detection
Fusing thermistor open
Causes: Thermistor defect MCU PWB defect Fusing section connector contact failure Power supply failure Fusing unit not installed

Code: H3-00

Description: Heat roller abnormally high temperature
Fusing temperature of 220 ~ 240°C.
Causes: Thermistor defect MCU PWB defect Fusing connector connection failure Power supply failure

Code: H4-00

Description: Heat roller abnormally low temperature
When the temperature does not reach 155°C within 55 sec after turning on the power, or when it falls under 145°C during printing, or when it falls under 100°C during pre-heating
Causes: Thermistor failure Heater lamp failure MCU PWB failure Thermostat failure Power supply failure Interlock switch failure

Code: L1-00

Description: Mirror base feed trouble
The mirror home position (MHPS) does not turn off though the feed operation is completed during mirror initial operation after turning on the power. The mirror home position (MHPS) does not turn off during shading operation. The mirror home position (MHPS) does not turn on when the mirror base is returned for the specified time after copy feed is started and SPF scanning position shift is performed.
Causes: Mirror unit defect Mirror home position sensor defect MCU PWB defect Scanner wire disconnection

Code: L3-00

Description: Mirror base return trouble
The mirror home position (MHPS) does not turn on though the mirror base returning is completed during mirror initial operation after turning on the power. The mirror home position does not turn on when the mirror is returned to the home position during shading. The mirror home position (MHPS) does not turn on when the mirror base returning is completed for the specified time (about 6 sec) after copy return start.
Causes: Mirror unit Mirror home position sensor defect MCU PWB defect Scanner wire disconnection
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie