Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Sharp AR317FP — Trang 4/13

Code: F1-06

Description: Offset motor trouble
When the offset motor of the finisher is driven it does not reach the specified position.
Causes: Offset motor abnormality Offset motor origin sensor abnormality Finisher PWB abnormality
Remedy: (AR-FN5A) Use SIM 3-3-6 to check the offset motor operation (AR-F14N) Use SIM 3-3-6 to check the slide motor operation

Code: F1-08

Description: Staple motor error
The staple motor cannot return to the home position.
Causes: Staple motor abnormality Staple motor home position sensor abnormality Staple unit abnormality Finisher PWB abnormality
Remedy: Use SIM 3-3-7 to check the staple motor operation

Code: F1-10

Description: Staple motor trouble
Staple motor operation abnormality
Causes: Motor lock. Motor rpm abnormality. Overcurrent to the motor. Finisher control PWB trouble.
Remedy: Use SIM 3-3-5 to check the staple motor operation

Code: F1-11

Description: Rear edge plate home position error
The rear edge plate cannot return to the home position.
Causes: Rear edge plate drive motor abnormality Side guide plate home position sensor abnormality Finisher PWB abnormality
Remedy: (AR-FN5A) Use SIM 3-3-2 to check the rear edge plate motor operation (AR-F14N) Use SIM 3-3-9 to check the bundle exit motor operation

Code: F1-15

Description: Finisher lift-up motor trouble
The finisher lift-up motor does not reach the specified position.
Causes: Lift-up motor abnormality Lift-up motor upper limit sensor abnormality Finisher PWB abnormality
Remedy: Use SIM 3-3-5 to check the lift-up motor operation

Code: F1-19

Description: Alignment motor (F) trouble
Alignment motor operation abnormality
Causes: Motor lock. Motor rpm abnormality. Overcurrent to the motor. Finisher control PWB trouble.
Remedy: Use SIM3-3-8 to check the alignment (F) motor operation.

Code: F1-20

Description: Alignment motor (R) trouble
Alignment motor operation abnormality
Causes: Motor lock. Motor rpm abnormality. Overcurrent to the motor. Finisher control PWB trouble.
Remedy: Use SIM3-3-7 to check the alignment (R) motor operation

Code: F1-30

Description: Finisher interface error
Communication line test error occurs when power is turned on or after the exit of a simulation mode. Error in console finisher communication
Causes: Connection trouble or disconnection of the connector and harness between the body and the finisher. Finisher control PWB trouble. Control PWB (PCU) failure. Malfunction by noises.
Remedy: Canceled by turning OFF/ON the power. Check the connectors and the harness of communication line Replace the finisher control PWB.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie