Description: MC trouble. Main charger output abnormality (Output open) Trouble signal is outputted from the high voltage transformer.
Causes: The main charger is not installed properly. The main charger is not assembled properly. Disconnection of connector of high voltage transformer. High voltage harness disconnection or breakage.
Remedy: Use the diag mode or DIAG to check the main charger output. Check for disconnection of the main charger. Replace the high voltage unit.
Description: Laser trouble. BD signal from LSU is kept OFF, or ON.
Causes: The connector of LSU or the harness in LSU is disconnected or broken. The polygon motor does not rotate normally. The laser home position sensor in LSU is shifted. The proper voltage is not supplied to the power line for laser. Laser emitting diode trouble PCU PWB trouble Controller PWB trouble
Remedy: Check for disconnection of the LSU connector. Use DIAG (SIM 61-1) to check LSU operation. Check that the polygon motor rotates normally or not. Check light emission of laser emitting diode. Replace the LSU unit. Replace the PCU PWB. Replace the Controller PWB.
Description: HDD trouble. HDD does not operate properly in the machine with HDD installed.
Causes: HDD is not installed properly to the Controller PWB. HDD does not operate properly in the Controller PWB. Controller PWB trouble
Remedy: Check installation of HDD to the Controller PWB. Check connection of the harness of HDD to the Controller PWB. Use DIAG (SIM 62-2, -3) to check read/write of HDD. Replace HDD. Replace Controller PWB.
Description: Decode error trouble. A decode error occurs during making of an image.
Causes: Data error during input from PCI to PM. PM trouble Data error during image compression/ transfer. Controller PWB abnormality
Remedy: Check insertion of the PWB. (PCI bus) If the error occurred in a FAX job, check installation of the FAX PWB. For the other cases, check the Controller PWB. Replace the Controller PWB.
Description: Finisher (AR-FN6) communication trouble. Communication cable test error after turning on the power or exiting from DIAG. Communication error with the finisher
Causes: Improper connection or disconnection of connectors and harness between the machine and the finisher. Finisher control PWB trouble Control PWB (PCU) trouble Malfunction by noises
Remedy: Canceled by turning OFF/ON the power. Check connectors and harness in the communication line. Replace the finisher control PWB or PCU PWB.
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.