Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Sharp AR507 — Trang 2/11

Code: E7 13

Description: CCD light quantity check error. Copy lamp light amount adjustment in shading cannot be made
Causes: Copy lamp does not light (broken wire, improper installation) Improper installation of flat cable to CCD unit Improper connection of copy lamp CL lead wire Mirror, lens, or reference white plate Dirt or dew Improper output of copy lamp power supply Improper installation of CCD unit CCD unit error ICU PWB error
Remedy: Clean mirror, lens, reference white plate. Check copy lamp for light amount (SIM5-3) and lighting. Check CCD unit. Check ICU PWB.

Code: E7 90

Description: ICU communication trouble (PCU detection). Communication setup error/framing/parity/protocol error
Causes: Slave unit PWB connector improper connection Slave unit PWB – ICU PWB harness trouble Slave unit PWB mother board connector pin breakage
Remedy: Check the slave unit PWB and the ICU PWB connector connection. Check the copier earth.

Code: EE EL

Description: Auto developing adjustment trouble (overtoner). A sample data is less than 0 when auto developing adjustment is executed.
Causes: Toner density sensor defective Charging voltage or developing voltage improper. Toner density improper Developing unit defective PCU PWB defective
Remedy: Make auto developing adjustment with SIM25-2.

Code: EE EU

Description: Auto developing adjustment trouble (undertoner). A sample data is less than 99 when auto developing adjustment is executed.
Causes: Toner density sensor defective Charging voltage or developing voltage improper Toner density improper Unit defective PCU PWB defective
Remedy: Make auto developing adjustment with SIM25-2.

Code: F1 00

Description: Finisher communication trouble. Communication line test error occurs when power is turned on or after the exit of a simulation mode. Improper communication with sorter
Causes: Improper connection or broken wire of connector or harness between copier and sorter Finisher control PWB defective Control PWB (PCU) defective Malfunction due to noise
Remedy: Clear by turning the power supply OFF/ON. Check communication line connector and harness. Replace Finisher control PWB or PCU PWB.

Code: F1 01

Description: Finisher1 jogger shift trouble / Finisher 2 alignment section abnormality. ogger shift trouble / Alignment plate shift trouble
Causes: Motor lock Motor rpm abnormality Motor overcurrent Finisher control PWB trouble
Remedy: Check the jogger motor operation with SIM 3-3.

Code: F1 02

Description: Finisher transport motor abnormality. Transport motor drive trouble
Causes: Motor lock
Remedy: Check transport motor operation with SIM3-3.

Code: F1 03

Description: Sorter guide bar oscillation motor trouble. Sorter guide bar oscillation motor drive abnormality
Causes: Motor lock. Motor rotation abnormality. Overcurrent to motor Sorter control PWB abnormality
Remedy: Check the guide bar motor operation with SIM3-3.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie