Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Sharp AR5127 — Trang 4/10

Code: EE EL

Description: Developer adjustment trouble (Over-toner abnormality). An abnormality occurred in execution of automatic developer adjustment. Sample data over-toner was detected.
Causes: Toner concentration sensor abnormality Toner concentration trouble Developing unit trouble MCU PWB failure
Remedy: Use SIM 25-2 to perform the auto developer adjustment.

Code: EE EU

Description: Developer adjustment trouble (Undertoner abnormality). An abnormality occurred in execution of automatic developer adjustment. Sample data under-toner was detected.
Causes: Toner concentration sensor abnormality Toner concentration trouble Developing unit trouble MCU PWB failure
Remedy: Use SIM 25-2 to perform the auto developer adjustment.

Code: F1 00

Description: Finisher communication trouble. Communication line test error occurs when power is turned on or after the exit of a simulation mode. Error in Finisher communication
Causes: Connection trouble or disconnection of the connector and harness between the body and the finisher. Finisher control PWB trouble Control PWB failure Malfunction by noises
Remedy: Turn off/of the power to cancel the trouble. Check connector/harness of communication line Replace the finisher control PWB.

Code: F1 01

Description: Side guide plated home position error. The side guide plate cannot return to the home position.
Causes: Side guide plate drive motor abnormality Side guide plate home position sensor abnormality
Remedy: Use SIM3-3-1 to check the side guide plate motor operation.

Code: F1 06

Description: Offset motor trouble. When the offset motor of the finisher is driven it does not reach the specified position.
Causes: Offset motor abnormality Offset motor origin sensor abnormality Finisher PWB abnormality
Remedy: Use SIM 3-3-6 to check the offset motor operation.

Code: F1 08

Description: Staple motor error. The staple motor cannot return to the home position.
Causes: Staple motor abnormality Staple motor home position sensor abnormality Staple unit abnormality
Remedy: Use SIM 3-3-7 to check the staple motor operation.

Code: F1 11

Description: Rear edge plate home position error. The rear edge plate cannot return to the home position.
Causes: Rear edge plate drive motor abnormality Side guide plate home position sensor abnormality Finisher PWB abnormality
Remedy: Use SIM 3-3-2 to check the rear edge plate motor operation.

Code: F1 15

Description: Finisher lift-up motor trouble. The finisher lift-up motor does not reach the specified position.
Causes: Lift-up motor abnormality Lift-up motor upper limit sensor abnormality Finisher PWB abnormality
Remedy: Use SIM 3-3-5 to check the lift-up motor operation.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie