Mã lỗi Sharp ARM318 — Trang 6/13
Description: Punch dust sensor trouble
Punch dust sensor detection trouble
Causes: Sensor breakage. harness breakage. Finisher control PWB trouble.
Remedy: Use SIM3-2 to check the punch dust sensor operation
Description: Punch power trouble
Panch unit power discontinuity detection
Causes: Punch control PWB defect
Remedy: Replace the punch control PWB
Description: Finisher incompatibility error
Speed does not coincide between finisher and main unit
Causes: AR-FN5N/F14 is connected to 31 sheet model
Remedy: Connect AR-FN5A. Connect AR-F14N.
Description: Interface transport unit connection trouble
Interface transport unit connector disconnection
Causes: Improper connection of connector between the finisher and the interface transport unit
Remedy: Check the interface transport unit connector.
Description: Transport motor trouble
Transport motor trouble
Causes: Motor lock. Motor rpm abnormality. Overcurrent to the motor. Finisher control PWB trouble.
Remedy: Use SIM3-3-11 to check the front transport motor operation
Description: Toner supply failure
The value judged from the actual toner supply hysteresis differs greatly from the toner sensor value.
Causes: Developing unit trouble Toner supply abnormality caused by installation of unpacked toner cartridge
Remedy: Replace the developing unit. Use SIM 25-1 to perform DV stirring.
Description: Identification error
Identification error When the CRUM trademark differs. When the CRUM company code differs.
Causes: CRUM chip failure Erroneous developing unit
Remedy: Replace the CRUM chip. Replace the developing unit.
Description: Temperature humidity sensor abnormality
Causes: Temperature humidity sensor connector disconnection. Short-circuit of the temperature humidity sensor was detected.
Remedy: Check the connection of temperature humidity sensor. Replace the temperature humidity sensor.