Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Sharp ARM450N — Trang 3/12

Code: E7-50

Description: LSU connection trouble
An LSU which does not conform to the machine is installed.
Causes: PCU PWB trouble LSU trouble
Remedy: Check LSU PWB. Check PCU PWB. Check connection of the connector and the harness between PCU and LSU.

Code: E7-80

Description: Communication trouble (ICU detection) between ICU and scanner
Communication establishment error/Fleming/ Parity/Protocol error
Causes: Defective connection of slave unit PWB connector Defective harness between slave unit PWB and Controller PWB Slave unit PWB mother board connector pin breakage
Remedy: Check connector and harness of slave unit PWB and Controller PWB. Check grounding of machine.

Code: E7-90

Description: PCU communication trouble
Communication establishment error/Fleming/ Parity/Protocol error
Causes: Defective connection of slave unit PWB connector Defective harness between slave unit PWB and Controller PWB Slave unit PWB mother board connector pin breakage
Remedy: Check connector and harness of slave unit PWB and Controller PWB. Check grounding of machine.

Code: EE-EL

Description: Auto developer adjustment trouble (Over-toner)
The sample data is at 68 or below when auto developer adjustment is performed.
Causes: Toner concentration sensor trouble Charging voltage, developing voltage abnormality Insufficient toner concentration Developing unit trouble PCU PWB trouble
Remedy: Use DIAG (SIM25-2) to perform auto developer adjustment.

Code: EE-EU

Description: Auto developer adjustment trouble (Under-toner)
The sample data is of 168 or above when auto developer adjustment is performed.
Causes: Insufficient toner concentration Charging voltage, developing voltage abnormality Insufficient toner concentration Developing unit trouble PCU PWB trouble
Remedy: Use DIAG (SIM25-2) to perform auto developer adjustment.

Code: F1-00

Description: Finisher (AR-FN6) communication trouble
Communication cable test error after turning on the power or exiting from DIAG. Communication error with the finisher
Causes: Improper connection or disconnection of connectors and harness between the machine and the finisher. Finisher control PWB trouble Control PWB (PCU) trouble Malfunction by noises
Remedy: Canceled by turning OFF/ON the power. Check connectors and harness in the communication line. Replace the finisher control PWB or PCU PWB.

Code: F1-00

Description: Mail-bin stacker (AR-MS1) communication trouble
Communication cable test error after turning on the power or exiting from DIAG. Communication error with the Mail-bin stacker.
Causes: Improper connection or disconnection of connector and harness between the machine and the Mail-bin stacker. Mail-bin stacker control PWB trouble Control PWB (PCU) trouble Malfunction by noises
Remedy: Canceled by turning OFF/ON the power. Check harness and connector in the communication line. Replace the Mail-bin stacker PWB or PCU PWB.

Code: F1-02

Description: Mail-bin stacker (AR-MS1) transport motor abnormality
Transport motor trouble
Causes: Motor lock Motor rpm abnormality Overcurrent to the motor Mail-bin stacker control PWB trouble
Remedy: Use DIAG (SIM3-3) to check the motor operation
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie