• Code: EAC
• Description: Finisher saddle stitcher transport delay jam
• Remedy:

• Code: EAD
• Description: Print end command time-out jam
• Remedy:

• Code: EAE
• Description: Finisher receive time-out jam
• Remedy:

• Code: EB3
• Description: Finisher ready time-out error
• Remedy:

• Code: EB5
• Description: PSTPR-L standby time-out error
• Remedy:

• Code: EB6
• Description: PSTPR-H standby time-out error
• Remedy:

• Code: F07
• Description: Communication error between SYS and LGC boards
• Remedy: (1) Check the connectors J102 and J108 on the SYS board for disconnection. (2) Check the connector J330 on the LGC for disconnection. (3) Check the connector J2 on the SLG board for disconnection. (4) Check the harness between the SYS and the SLG for breaks and disconnected pins. (5) Check the harness between the SYS and the LGC for breaks and disconnected pins. (6) Check the FROM version on the SYS board. (7) Check the MROM (IC36) version on the LGC board. (8) Check the SROM version on the SLG board. (9) Replace the SYS board. (10) Replace the SLG board. (11) Replace the LGC board.

• Code: F10
• Description: HDD formatting error
• Remedy: (1) Perform the “HDD formatting” (Setting Mode: 08 -> 690 -> 2). (2) Make sure that the HDD is mounted. (3) Make sure that a dedicated HDD is mounted. (4) Make sure that the HDD connector pins are not bent. (5) Check HDD connector J106 on the SYS board for disconnection. (6) Replace the harness. (7) Replace the HDD. (8) Replace the SYS board.