Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Toshiba e-Studio 170F — Trang 5/6

Code: C3

Description: After detecting a high-speed signal, EOL was not detected for 15 seconds.
Remedy: This may happen in some cases of bad line condition. Ask the remote party to transmit again.

Code: C4

Description: The EOL timer has timed out.
Remedy: This may happen in some cases of bad line condition. Ask the remote party to transmit again.

Code: D0

Description: Post response signal was not detected on the sending side. Post signal was not detected on the receiving side.
Remedy: This may happen in some cases of bad line condition. Attempt the transmission again. Or ask the remote party to attempt the transmission again.

Code: D1

Description: DCN is received.
Remedy: This may happen in some cases of bad line condition. Ask the remote party to transmit again.

Code: D2

Description: RTN/PIN is received on the sending side. RTN/PIN is received on the receiving side.
Remedy: This may happen in some cases of bad line condition. Ask the remote party to transmit again.

Code: E0

Description: A printer error occurred during a reception, and the machine is shifted into memory reception mode. However, there was not enough residual memory
Remedy: Remove the cause of the printer error, then ask the remote party to transmit again.

Code: E6

Description: An error relating to the printer has occurred.
Remedy: Confirm details of the error using the error code and correct the error. Then ask the remote party to transmit again.

Code: F0

Description: The communication ended because of a WDT due to an overrun of the software.
Remedy: Attempt the communication again. If the error occurs frequently, perform a memory clear (except user area.)
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie