• Code: F104
• Description: HDD data error: Abnormality is detected in the data of HDD.
• Remedy: (1) Check if the connectors of the HDD are disconnected. (2) Check if the connector pins are disconnected or the wires of harnesses are broken. (3) Perform the bad sector check (08-694). If the check result is OK, recover the data in the HDD. If the check result is failed, replace the HDD. (4) Replace the SYS board.

• Code: F105
• Description: HDD other error
• Remedy: (1) Check if the connectors of the HDD are disconnected. (2) Check if the connector pins are disconnected or the wires of harnesses are broken. (3) Perform the bad sector check (08-694). If the check result is OK, recover the data in the HDD. If the check result is failed, replace the HDD. (4) Replace the SYS board.

• Code: F106
• Description: Point and Print partition damage
• Remedy: (1) Turn the power OFF and start up the Setting Mode (08). (2) Key in “662” and press the [START] button. (Partition clearing is performed.) (3) Restart the equipment. (4) Access TopAccess. Click the [Administration] tab, and then click the Maintenance Menu to open. Then install the “Point and Print” driver.

• Code: F107
• Description: SHR partition damage
• Remedy: Initialize the Electronic Filing using the Setting Mode (08-666).

• Code: F108
• Description: SHA partition damage
• Remedy: Initialize the shared folder using the Setting Mode (08-667).

• Code: F110
• Description: Communication error between System-CPU and Scanner-CPU
• Remedy: (1) Check if the jumper pin setting on the SYS board is correct. (Check if a jumper pin is inserted between Pin 1 and Pin 2 of the CN 103 and the CN115.) (2) Check if the harness connecting the SYS board and SLG board is disconnected or open circuited. (3) Check the version of the system ROM on the SYS board. (4) Check the version of the scanner ROM version on the SLG board. (5) Replace the SYS board. (6) Replace the SLG board.

• Code: F111
• Description: Scanner response abnormality
• Remedy: (1) Check if the jumper pin setting on the SYS board is correct. (Check if a jumper pin is inserted between Pin 1 and Pin 2 of the CN 103 and the CN115.) (2) Check if the harness connecting the SYS board and SLG board is disconnected or open circuited. (3) Check the version of the system ROM on the SYS board. (4) Check the version of the scanner ROM version on the SLG board. (5) Replace the SYS board. (6) Replace the SLG board.

• Code: F120
• Description: Database abnormality: Database is not operating normally.
• Remedy: (1) Rebuild the databases. (Perform 08-684.) (2) If the error is not recovered, initialize the HDD. (Key in “2” at 08-690.)