Code :

Code: F600
Description: Software update error
Causes:
Remedy: Setting 1. Perform [3] + [C] + [POWER] → [1] → [START] for "Clear Error Flag in Software Installation". 2. Reinstall the firmware in error displayed on the F600 error screen.

Code: F700
Description: Overwrite error
Causes:
Remedy: Setting • If a service call occurs again after the reboot, replace the HDD.

Code: F800
Description: Date error
Causes:
Remedy: Setting Reset the date, and request the administrator to set the date and time. 1. Turn the power on while pressing the [6] and [CLEAR] button. 2. Select [2] key, and then press the [START] button. 3. Press the [START] button on the confirmation screen displayed. (The date is set to January 1st, 2011.) 4. Request the administrator to set the date and time.

Code: F900
Description: Machine information alignment error
Causes:
Remedy: Setting Recover the machine information by means of the following procedure. <Machine information recovery> 1. Turn the power ON while pressing [6] and the [CLEAR] button simultaneously. 2. Key in [3] to select "3. SRAM Re-Initialize Support", and then press the [START] button. 3. After the operation is completed, shut down the equipment by pressing the [ON/OFF] button. * If it is not recovered, perform the following procedure. 4. Turn the power ON while pressing [3] and the [CLEAR] button simultaneously. 5. Enter the password on the Authentication screen. If no password is set for Service, press the [OK] button without entering anything. If the High Security Mode has been set, enter "#1048#". 6. Key in [5] to select "5. Key Backup Restore", and then press the [START] button. 7. Key in [2] to select "2. Key FROM to SRAM", and then press the [START] button. 8. After the operation is completed, shut down the equipment by pressing the [ON/OFF] button.

Code: F902_1
Description: System firmware / System software model information error - Invalid system firmware/ software is installed.
Causes: LGC board
Remedy: Setting 1. Confirm the model of the equipment. 2. Install the HDD. 3. Install the system firmware corresponding to the model. ([8]+[9] mode) "11.4.2 System firmware" 4. Install the system software corresponding to the model. ([4]+[9] mode ¡÷ [4]) ƒt P. 11-8 "11.2.2 Update procedure"

Code: F902_4
Description: SYS board model information error
Causes:
Remedy: SYS board Check if the model of the equipment matches the color of the label on the SYS board. <Color of label> • 25/30/35ppm: Yellow or pink • 45/50ppm: Blue or brown Fig.8-1 Setting 1. Install the system firmware. 2. If the error cannot be solved after installing the system firmware, reinstall the system software and application program.