Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Toshiba e-Studio 5500c — Trang 19/34

Code: SC531

Description: Fan error 2: fusing cooling fan motor. The lock signal remained HIGH for 5 sec. while the fan at the front of the fusing unit near the heat dissipation fins was operating.
Remedy: • Motor overload due to obstacle interfering with operation of the fan • Fan harness loose, disconnected, defective • Fan defective

Code: SC532

Description: Fan error 3: PCB box fan. The lock signal remained HIGH for 5 sec. while the fan that cools the printed circuit boards was operating.
Remedy: • Motor overload due to obstacle interfering with operation of the fan • Fan harness loose, disconnected, defective • Fan defective

Code: SC533

Description: Fan error 4: fusing exhaust fan. The lock signal remained HIGH for 5 sec. while the fan that draws air out of the fusing unit was operating.
Remedy: • Motor overload due to obstacle interfering with operation of the fan • Fan harness loose, disconnected, defective • Fan defective

Code: SC534

Description: Fan error 5: duplex exhaust fan. The lock signal remained HIGH for 5 sec. while the fan that draws air out of the duplex unit was operating.
Remedy: • Motor overload due to obstacle interfering with operation of the fan • Fan harness loose, disconnected, defective • Fan defective

Code: SC535

Description: Temperature/Humidity control abnormal. The output of the temperature/humidity sensor reaches the upper or lower limit, even after the Peltier unit has been ON for 3 hours.
Remedy: • Peltier Cooling Fan Motor is defective.

Code: SC541

Description: Heating roller thermistor 1 error 1: Poor connection. The temperature measured by the heating roller thermistor does not reach 130°C after 10 tries and 65 sec. have elapsed.
Remedy: • Heating roller thermistor harness connection loose, disconnected, defective • Defective heating roller thermistor

Code: SC542

Description: Heating roller thermistor 1 error 2: No warmup. After the main switch is turned ON or the cover is closed, the heating roller temperature does not reach the ready temperature within 2 sec. after the heater switches ON. -or- If the roller was below 45°C, the heating roller did not reach the ready temperature 2 sec. after reaching 45°C. Note: Thermistor 2 stops monitoring the temperature once Thermistor 1 detects ready temperature.
Remedy: • Thermistor is bent, installed incorrectly • Defective heating roller thermistor • Heating roller fusing lamp broken Do SP5810 to cancel the SC fusing code.

Code: SC543

Description: Heating roller thermistor 1 error 3: Software - High temperature. The thermistor detected a temperature over 230°C.
Remedy: • TRIAC short • IOB defective • BICU defective • Fusing temperature out of control Do SP5810 to cancel the SC fusing code.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie