Remedy: Is the transport roller tainted? → YES . Clean up the roller. NO Is the harness between the inserter control board and transport sensor is open-circuited? → YES . Replace the harness. NO Is the transport sensor working impropely? → YES . Replace the transport sensor. NO Replace the inserter control board.
Remedy: Is the transport roller tainted? → YES . Clean up the roller. NO Is the harness between the inserter control board and transport sensor is open-circuited? → YES . Replace the harness. NO Is the transport sensor working impropely? → YES . Replace the transport sensor. NO Replace the inserter control board.
Remedy: Is the transport roller tainted? → YES . Clean up the roller. NO Is the harness between the inserter control board and transport sensor is open-circuited? → YES . Replace the harness. NO Is the transport sensor working impropely? → YES . Replace the transport sensor. NO Replace the inserter control board.
Description: Paper remaining in Inserter Unit at power-ON
Remedy: Is there any paper remaining at the inserter transport path? → YES . Remove the paper. NO Are the separation sensor, reverse path sensor and transport sensor working improperly? → YES . Replace the sensors. NO Replace the inserter control board.
Description: Incorrect setting of paper size for Inserter Unit
Remedy: Is the paper size on the inserter tray consist with the size set at the copier control panel? → NO . Set the same paper size as that on the tray. YES Is the separation sensor working improperly? → YES . Replace the separation sensor. NO Perform the width adjustment of the inserter tray side guide.
Remedy: Is the condition improved when the copier power switch is turned OFF/ON? → NO 1) Replace the copier LGC board. 2) Replace the IPC board. 3) Replace the inserter control board.
Remedy: Is the problem solved by opening the inserter jam access cover? → NO 1) Check the installation state of the cover. 2) Replace the cover switch and plate spring.
Description: Communication error between System-CPU and Engine-CPU
Remedy: (1) Check if the connector CN102, CN103 on the SYS board is disconnected. (2) Check if the connector CN10 on the SLG board is disconnected. (3) Check if the harness connecting the SYS board and SLG board is disconnected or open circuited. (4) Check if the harness connecting the SYS board and LGC board is disconnected or open circuited. (5) Check the version of the system ROM on the SYS board. (6) Check the version of the engine ROM version on the LGC board. (7) Check the version of the scanner ROM version on the SLG board. (8) Replace the SYS board. (9) Replace the SLG board. (10) Replace the LGC board.
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.