Description: Waste toner transport motor locking error: The auger in the waste toner transport path does not rotate.
Causes: Waste toner transport motor Auger lock detection sensor EPU board LGC board
Remedy: EPU tray (process unit) • Pull out the process unit, rotate the gear counterclockwise and check if the load is extremely heavy. • Is the load still extremely heavy after the gear is rotated for a while to discharge the toner from the waste toner transport path? • Is the load still extremely heavy after the actuator is removed, the auger is pulled out and clean them? Waste toner transport motor (M31) • Motor check (Perform the output check: 03-234) • Connector check • Harness check Auger lock detection sensor (S42) • Sensor check (Perform the input check: K: 03-[FAX]ON/[0]/[B]) • Connector check • Harness check EPU board • Connector check (CN551, CN557) • Board check LGC board • Connector check (CN308, CN331) • Board check
Remedy: TRU waste toner box • Check if the TRU waste toner box is full of used toner. Replace it, if it is full. TRU waste toner amount detection sensor (S13) • Sensor check (Perform the input check: K: 03-[ALL]OFF/[5]/[E]) • Connector check • Harness check ADU board • Connector check (CN491, CN497) • Board check PFC board • Connector check (CN511) • Board check
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.