Code :

Code: F105
Description: Other HDD errors
Remedy: (1) Check if the connectors of the HDD are disconnected. (2) Check if the connector pins are disconnected or the wires of harnesses are broken. (3) Perform the bad sector check (08-694). If the check result is OK, recover the data in the HDD. If the check result is failed, replace the HDD. (4) Replace the SYS board.

Code: F106
Description: Point and Print partition damage
Remedy: (1) Turn the power OFF and start up the Setting Mode (08). (2) Key in “662” and press the [START] button. (Partition clearing is performed.) (3) Restart the equipment. (4) Access TopAccess. Click the [Administration] tab, and then click the Maintenance Menu to open. Then install the “Point and Print” driver.

Code: F110
Description: Communication error between System-CPU and Scan-ner-CPU
Remedy: (1) Check if the connector CN102, CN103 on the SYS board is disconnected. (2) Check if the connector CN10 on the SLG board is disconnected. (3) Check if the harness connecting the SYS board and SLG board is disconnected or open circuited. (4) Check if the harness connecting the SYS board and LGC board is disconnected or open circuited. (5) Check the version of the system ROM on the SYS board. (6) Check the version of the engine ROM version on the LGC board. (7) Check the version of the scanner ROM version on the SLG board. (8) Replace the SYS board. (9) Replace the SLG board. (10) Replace the LGC board.

Code: F111
Description: Scanner response abnormality
Remedy: (1) Check if the connector CN102, CN103 on the SYS board is disconnected. (2) Check if the connector CN10 on the SLG board is disconnected. (3) Check if the harness connecting the SYS board and SLG board is disconnected or open circuited. (4) Check if the harness connecting the SYS board and LGC board is disconnected or open circuited. (5) Check the version of the system ROM on the SYS board. (6) Check the version of the engine ROM version on the LGC board. (7) Check the version of the scanner ROM version on the SLG board. (8) Replace the SYS board. (9) Replace the SLG board. (10) Replace the LGC board.

Code: F120
Description: Database abnormality: Databases do not run normally.
Remedy: (1) Rebuild the databases. (Perform 08-684.) (2) If the error is not recovered, initialize the HDD. (Enter “2” at 08-690.)

Code: F130
Description: Invalid MAC address
Remedy: Compare the serial number of the equipment with a number displayed in 08-995. If they are different, enter the correct serial number at 08-995.