Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Xerox Phaser 7800 — Trang 25/58

Code: 341.346

Description: MD PWB F3 Open. Fuse 3 on the MD PWB has blown.
Remedy: 1. Check the following parts circuits for overcurrent and overvoltage, and then replace the faulty parts or repair the circuits. • Tray Module PWB (PL 10.9 Item 1) 2. Turn the power Off and replace the MD PWB.

Code: 341.347

Description: Serial I/O Fault.
Remedy: 1. Turn the power Off and check the connector ( P/J452) between the MD PWB and the MCU PWB for poor connection. If no problems are found, replace the following parts in sequence: • MCU PWB • MD PWB

Code: 341.348

Description: MD PWB F4 Open. Fuse 4 on the MD PWB has blown.
Remedy: 1. Check the following Tray Module PWB parts circuits for overcurrent and overvoltage, and then replace the faulty part or repair the circuits. 2. Turn the power Off and replace the MD PWB.

Code: 341.349

Description: MD PWB F6 Open. Fuse 6 on the MD PWB has blown.
Remedy: 1. Check the following parts circuits for overcurrent and overvoltage, and then replace the faulty parts or repair the circuits. • Take Away Motor • Tray 2 Feed/Lift Up Motor (PL 9.4 Item 3) • P/R Latch Motor (PL 7.1 Item 4) • Agitator Motor 2. Turn the power Off and replace the MD PWB.

Code: 341.350

Description: MD PWB F7 Open.
Remedy: 1. Check the following parts circuits for overcurrent and overvoltage, and then replace the faulty parts or repair the circuits. • Fuser Fan • Front LVPS Fan • IH Intake Fan • C Exit Fan • Process 1 Fan 2. Turn the power Off and replace the MD PWB.

Code: 341.351

Description: MD Detect Fault. The MD PWB is not installed.
Remedy: 1. Turn the power Off and check the connector ( P/J452) between the MD PWB and the MCU PWB for poor connection. If no problems are found, replace the following parts in sequence: • MD PWB • MCU PWB

Code: 341.352

Description: MD PWB F5 Open. Fuse 5 on the MD PWB has blown.
Remedy: 1. Check the Finisher circuit for overcurrent and overvoltage, and then replace the faulty parts or repair the circuits. 2. Turn the power Off and replace the MD PWB.

Code: 341.353

Description: MD PWB F8 Open. Fuse 8 on the MD PWB has blown.
Remedy: 1. Check the following parts circuits for overcurrent and overvoltage, and then replace the faulty parts or repair the circuits. • Tray 1 Feed/Nudger Motor (PL 13.2 Item 6) • Exit 2 Drive Motor (PL 17.4 Item 5) • Duplex Motor 2. Turn the power Off and replace the MD PWB.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie