Code: 13.12.11
Display: 13.12.11
Description: Finisher stay jam at either PI33 or PI34 when engine powered on. When the engine is powered on, the finisher's upper-feed-path-entry sensor (PI33) or the upper-feed-path-exit sensor (PI34) is activated suggesting that there is paper in the upper paper path of the finisher at sensors PI33 or PI34.
Remedy: Signal generated from PI33 (upper-feedpath- entry sensor) and PI34 (upper-feedpath- exit sensor) 1. Open the top door and remove any media in the paper path (media detected at PI33). 2. Raise the upper paper path (exit) delivery rollers and remove any media in the paper path (media detected at PI34). 3. Check these sensors for obstructions. Verify that the sensor flags are not damaged, move freely, and are correctly aligned with the sensor body and properly mounted. Also check wiring and connectors for damage or loose connections. 4. Carefully clean the sensor body by gently blowing clean air across the sensor to remove dust and debris. 5. Verify that the sensor connectors (J708 and J707) are fully seated on the stacker controller PCA. 6. Replace sensor PI33 and PI34. 7. Only if the error persists and the previous steps fail to correct the problem, replace the stacker controller PCA.