Code: 66.12.21
Display: 66.12.21
Description: Finisher upper-stapler-motor failure (M41) Error occurs either when the stapler does not leave stapler home position (PI50) after staple motor (M41) is driven for 0.4 seconds or when it does not return to stapler home position after the staple motor has detected a motor lock condition and the motor is driven backwards for 0.4 seconds, attempting to reach home position. NOTE: PI50 and M41 are located on the stapler assembly and can only be replaced by replacing entire stapler assembly. M41 (staple motor) drives the insertion and crimping of the staple only (not location of the staple on paper). PI50 senses the home position of the stapler as it is inserting and crimping a staple only (not location of the staple on the paper). The stapler-safety switch (MS34) that assures that stapler motor (M41) is disabled when it senses a finger may be in the stapler.
Remedy: Control panel diagnostics: none 1. Check the stapler unit for jammed staples. 2. Check the stapler unit for loose staples and paper dust. 3. Make sure that the stapler unit is fully seated. 4. Verify that connector J717 on the stacker controller PCA is fully seated and not damaged. Check the wiring at the stapler unit and the stapler PCA. 5. Replace the stapler.