Code: 66.12.31
Display: 66.12.31
Description: Finisher error - 1st tray lift/lower motor (M37) Occurs when the output bin 1 does not activate the home-position sensor (PI41) when the output-bin-1 shift motor (M37) is driven for 20 seconds. Also occurs when output bin 1 does not move when output-bin-1 shift motor (M37) is driven for 4 seconds. Also occurs when output-bin-1 switch (MSW33) is activated while output bin 1 is operating. NOTE: Output-bin-1 home position is detected using the top sheet of paper on the bin when paper is present and the edge of the bin itself when there is no paper on the bin.
Remedy: Control panel diagnostics: M37 tray 1 (output bin 1 motor) NOTE: M37 moves both output bin 1 and the upper-output bin that is attached to output bin 1 on the stapler/stacker finisher, but only output bin 1 on the booklet-maker finisher. 1. Manually release output bin 1, and position it at the mid point of its travel area. Test the output-bin-1 shift motor M37 by using the finisher component test from the control-panel display. • If output bin 1 moves during the test, perform the following steps. • If the paper-surface sensor flag was recently removed or replaced, make sure that it is installed correctly. NOTE: The four tabs under the clips must be inserted into the slots behind the roller shaft of the lower-stack ejection roller. • Verify that the paper-surface sensor flag is not damaged, moves freely, and is correctly aligned with the PI41 sensor body. Also verify that when the top edge of the output bin engages the sensor arm that the sensor flag moves into sensor PI41. • Make sure that the sensor is securely fastened to the chassis. • Carefully clean the sensor body by gently blowing clean air across the sensor to remove dust and debris. • Verify that intermediate connector J1040 and J721 on the stacker controller PCA are fully seated and not damaged. Check the wiring at the sensor. • If the error persist, replace sensor PI41. • If the error persist, replace the output-bin-1 assembly. NOTE: The output-bin-1 assembly includes the output-bin-1 shift motor (M37), output-bin-1 switch (MSW33), output-bin-1 area sensors, and the output-bin-1 driver PCA. 2. If output bin 1 does not move during the test, perform the following steps. • Check the output-bin tracks for damage. • Replace the output-bin-1 assembly NOTE: The output-bin-1 assembly includes the output-bin-1 shift motor (M37), output-bin-1 switch (MSW33), output-bin-1 area sensors, and the output-bin-1 driver PCA. • Only if the error persists and the previous steps fail to correct the problem, replace the stacker controller PCA.