Code: 50.4X.YZ
Display: 50.WX.YZ Fuser error To continue turn off then on
Description: Drive circuit fault
The fuser has experienced an error. W = fuser error code, X = fuser mode, Y = previous printer sleep state, Z = next printer sleep state
Fuser modes: • Normal.Auto Sense • Normal • Light 1 • Heavy 1 • Heavy 2 • Heavy 3 • Glossy 1 • Glossy 2 • Glossy 3 • Glossy Film • Transparency • Label • Envelope 1 • Rough
Sleep states: • Standby level 1 (no temperature control) • Standby level 2 (high temperature control) • Standby level 3 (middle temperature control) • Standby level 2 (low temperature control) • Middle sleep • Deep sleep • Power off
The fuser has experienced an error. W = fuser error code, X = fuser mode, Y = previous printer sleep state, Z = next printer sleep state
Fuser modes: • Normal.Auto Sense • Normal • Light 1 • Heavy 1 • Heavy 2 • Heavy 3 • Glossy 1 • Glossy 2 • Glossy 3 • Glossy Film • Transparency • Label • Envelope 1 • Rough
Sleep states: • Standby level 1 (no temperature control) • Standby level 2 (high temperature control) • Standby level 3 (middle temperature control) • Standby level 2 (low temperature control) • Middle sleep • Deep sleep • Power off
Remedy: 1. Check the power source. Make sure the power source meets product requirements. NOTE: If the power source does not meet the power frequency requirement of 43 to 67Hz, the fuser temperature control does not work properly and causes this error. 2. If the error persists, replace the low-voltage power supply. 3. If this product has been previously serviced, check the connector (J21) on the DC controller PCA.