Code: 1106
Description: Power Error
The power supplies of +36, +24 and +12 V were diagnosed and could not be detected. This error is checked when the Printer is booted up.
The power supplies of +36, +24 and +12 V were diagnosed and could not be detected. This error is checked when the Printer is booted up.
Remedy: • Check the Window Sensors to make sure they are installed/connected correctly. Make sure that the Window lips (that activate the Window Sensors) are not bent and that the Window is closed correctly. • Check that the sensor cables are correctly connected to connector CN4 on the Main PCA and connector CN3 on the Heater Relay Board. • Check the lighting status of LED 35 (12V), LED 36 (36V), LED 37 (VDD2), and LED 38 (12V) on the Main PCA. If any LED is OFF, it mean the power is not generated properly. In that case, perform general troubleshooting according to the table below, and check whether there is a short-circuit in any of the parts or cables. • If the error continues, replace the Main PCA.