Code: 1180
Description: Pump/Wipe Motor Error
Over current is detected in the pump/wipe motor drive circuit.
Over current is detected in the pump/wipe motor drive circuit.
Remedy: • When the ambient temperature is very low, the Pump Motor Tube becomes hard and the load on the Capping Motor is increased. Make sure that the Printer is in an environment where the temperature is not below -10oC or higher than +85oC. • Enter the Motors Menu (in Maintenance Mode) and select "Forwards" to activate the Pump/Wipe Motor. Access the Pump Motor and check whether the Motor Drive Circuit and Motor work correctly. • Make sure that the Capping Station cables are connected correctly and are not damaged • If the Capping Motor cannot be rotated, replace the Capping Station Motor. • Make sure the Cap Sensor Cable is connected correctly and is not damaged. • Replace the Main PCA.