Display: Fuser Unit Failure #U1-2115 : Turn off then on. Fuser Unit Failure #U1-2116 : Turn off then on.
Description: The fuser unit can’t control the pressure device.
Remedy: 1) Open the rear cover. Lift up the right side and release the rear cover. 2) Check if the Actuator Cam Photo sensor is assembled correctly. 3) If there is no problem, remove 4 screws. 4) Lift up the both levers. Then take off the fuser unit. 5) Check if the exit sensor is assembled correctly. 6) Check if the photo sensor harness is connected correctly. 7) Remove the fuser side cover L/R. Check if the Actuator can, Gear cam are assembled correctly. 8) If there is no problem for above steps, assemble and reinstall fuser unit. Then turn the machine on. 9) If the same error persists, install the firmware again. 10)If the same error persists, replace the fuser unit with new one. 11) If the same error persists, replace the main board.