Description: Manual feed up/down abnormality. • Paper is not turned OFF (unblock) the bypass lift-up position sensor (PS26) even after the transport motor (M1) rotates for a given period of time after the position is switched from stand by position at lift-up plate to the feed position. • The bypass lift-up position sensor (PS26) is not turned ON (blocked) even after the transport motor (M1) rotates for a given period of time after the position is switched from stand by position at lift-up plate to the feed position.
Causes: • Transport motor (M1) • Bypass pick-up solenoid (SD1) • Bypass lift-up position sensor (PS26) • MFP board (MFPB)
Remedy: 1. Check the connector between M1-MFPB CN11E for proper connection and correct as necessary. 2. Check the connector of M1 for proper drive coupling and correct as necessary. 3. Check the connector between PS26-relay CN50-MFPB CN30E for proper connection and correct as necessary. 4. Check the connector between SD1-relay CN123-relay CN50-MFPB CN30E for proper connection and correct as necessary. 5. PS26 I/O check, sensor check • Control signal: MFPB CN30E-7 (ON) • Location of electrical component: 13-C 6. SD1 operation check • Control signal: MFPB CN30E-4 (ON) • Location of electrical component: 13-C 7. M1 operation check • Control signal: MFPB CN11E-4 (REM), MFPB CN11E-7 (FGP) • Location of electrical component: 3-C 8. Replace M1. 9. MFPB F12E, F21E conduction check 10. Replace MFPB. NOTICE • Link to the wiring diagram (N.1. bizhub C287/C227) • Link to the layout drawings for related parts by each trouble code (S.11. C0211)