• Code: 10-01
• Description: The leading edge of the paper is not turned ON (unblocked) the registration sensor (PS1) even after the lapse of a given period of time after the manual bypass tray starts to feed paper.
• Causes: • Transport motor (M1) • Registration clutch (CL4) • Bypass paper feed clutch (CL7) • Registration sensor (PS1) • MFP board (MFPB)
• Remedy:

• Code: 10-02
• Description: For paper fed from the manual bypass tray, loop forming has not been complete before a sheet enters the registration roller because the rise timing of load to perform registration is earlier than the rise timing of load to form a loop.
• Causes: • Transport motor (M1) • Registration clutch (CL4) • Bypass paper feed clutch (CL7) • Registration sensor (PS1) • MFP board (MFPB)
• Remedy:

• Code: 10-40
• Description: For paper fed from the manual bypass tray, the image write start signal permit continues to be disabled for a predetermined period of time after the timing of the image write start signal output.
• Causes: • Transport motor (M1) • Registration clutch (CL4) • Bypass paper feed clutch (CL7) • Registration sensor (PS1) • MFP board (MFPB)
• Remedy:

• Code: 11-01
• Description: The leading edge of the paper is not turned ON (unblocked) the registration sensor (PS1) even after the lapse of a given period of time after the tray 1 starts to feed paper.
• Causes: • Transport motor (M1) • Tray 1 paper feed clutch (CL3) • Registration clutch (CL4) • Registration sensor (PS1) • MFP board (MFPB)
• Remedy:

• Code: 11-02
• Description: For paper fed from the tray 1, due to a delay in paper arrival, loop forming in front of the registration roller is not complete before the rise timing of the transport motor (M1).
• Causes: • Transport motor (M1) • Tray 1 paper feed clutch (CL3) • Registration clutch (CL4) • Registration sensor (PS1) • MFP board (MFPB)
• Remedy:

• Code: 11-40
• Description: For paper fed from the tray 1, the image write start signal permit continues to be disabled for a predetermined period of time after the timing of the image write start signal output.
• Causes: • Transport motor (M1) • Tray 1 paper feed clutch (CL3) • Registration clutch (CL4) • Registration sensor (PS1) • MFP board (MFPB)
• Remedy:

• Code: 12-01
• Description: The leading edge of the paper is not turned ON (unblocked) the tray 2 vertical transport sensor (PS19) even after the lapse of a given period of time after the tray 2 starts to feed paper.
• Causes: • Transport motor (M1) • Tray 2 paper feed clutch (CL1) • Tray 2 vertical transport clutch (CL2) • Tray 2 vertical transport sensor (PS19) • MFP board (MFPB)
• Remedy:

• Code: 12-40
• Description: For paper fed from the tray 2, the image write start signal permit continues to be disabled for a predetermined period of time after the timing of the image write start signal output.
• Causes: • Transport motor (M1) • Tray 2 paper feed clutch (CL1) • Tray 2 vertical transport clutch (CL2) • Tray 2 vertical transport sensor (PS19) • MFP board (MFPB)
• Remedy: