Remedy: 1. Perform image troubleshooting procedure if image density is low. 2. Reinstall the imaging unit. 3. Reinstall the developing unit/K. 4. Reinstall the toner cartridge. 5. Check the connector between the imaging unit or developing unit/K-relay CN161,CN162,CN163,CN164-relay CN15-MFPB CN18E for proper connection and correct as necessary. 6. M10 operation check • Control signal: MFPB CN26E-1 to 4 • Location of electrical component: 20-J 7. M7, M9 operation check • Control signal: MFPB CN28E-1 to 4 (M7), MFPB CN28E-5 to 8 (M9) • Location of electrical component: 19-J 8. If the toner empty sensor and its surroundings inside the sub hopper are dirtied with toner, clean them. 9. Replace the the corresponding imaging unit. 10. Replace the developing unit/K. 11. Replace MFPB. NOTICE • Link to the wiring diagram (N.1. bizhub C287/C227) • Link to the layout drawings for related parts by each trouble code (S.43. C2551) • Link to the layout drawings for related parts by each trouble code (S.45. C2553) • Link to the layout drawings for related parts by each trouble code (S.47. C2555) • Link to the layout drawings for related parts by each trouble code (S.49. C2557)