Code: 929
Description: Toner Sensor
The toner sensor is not operating properly, the developer drive assembly is not operating properly or the print cartridge is defective.
The toner sensor is not operating properly, the developer drive assembly is not operating properly or the print cartridge is defective.
Remedy: 1 Developer Drive Assembly Incorrect operation of the developer drive assembly can cause the printer to display a 929 error code (Toner Sensor). Check the developer drive assembly for correct installation, any sign of worn, loose or broken parts. 2 Toner Sensor Cable Check the toner sensor assembly cable to make sure it is properly seated into the toner sensor. If correct at both the sensor and engine board (J10), check the continuity of the cable. If incorrect, replace the cable. 3 Toner Sensor The toner sensor cable is part of the front harness and part of connector J10 on the engine board. Check the voltage at J1-011. It reads approximately +5 V dc. If incorrect, replace the engine board. If correct, check the voltage at J10-12. It reads approximately +5 V dc with the controller board removed from the printer. If incorrect, replace the engine board. If correct, replace the toner sensor assembly. A bad ground connection between J10-13 on the engine board and pin 3 on the toner sensor results in a 929 service error.